
Contact for Pricing
Overview
- Offset pattern collinear design for focused signal transmission
- Frequency Range: 336-364 MHz
- Gain: 8 dBi
- Vertical Polarization
- Durable UV-resistant ABS/FG radome with PU foam filling (IP67 rated)
- Copper radiator for excellent conductivity
- N-/TNC-female connector for versatile connectivity
- VSWR: <1.5 for optimal signal integrity
- Mounting for 35-60 mm diameter poles
- DC-short circuited for lightning protection
Specifications
Connection Type | N-/TNC-female |
Connector | N-/TNC-female |
Frequency | 336-364 MHz |
Gain | 8 dBi |
Length | 1280 mm |
Material | ABS/FG PU foam, copper |
Mounting Diameter | Ø 35-60 |
Mounting Type | 35-60 mm diameter pole |
Polarization | vertical |
Radiator Material | copper |
Radome | ABS/FG, PU foam |
Series | CA350C2 |
VSWR | <1.5 |
Weight | 1690 g |
Wind Load | 72 N @ 150 km/h |

CA450C2
offset pattern collinear - Frequency range: 440-475 MHz - Gain: 8 dBi - Polarization: vertical - Connector: N-/TNC-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 64 NHow to Install the CA350C2 Controller
This guide provides step-by-step instructions for the installation and initial setup of the CA350C2 Controller, ensuring proper wiring and configuration.
Estimated time: 45m
Tools needed:
Screwdriver, Wire strippers, Multimeter
Supplies needed:
Mounting screws, Self-amalgamating tape, Terminal connectors
- Mount the controller
Secure the CA350C2 controller to the designated mounting surface using the provided mounting screws. Ensure it is level and securely fastened.
- Connect the wiring
Use terminal connectors to connect the power and signal wires to the appropriate terminals on the CA350C2 controller. Ensure all connections are tight and secure.
- Seal connections
Cover all connectors and cable junctions with self-amalgamating tape to protect against weather conditions. Ensure that the tape is applied evenly and securely.
- Verify connections
Use a multimeter to check the voltage at the controller terminals to ensure proper power supply. Confirm that all connections are functioning correctly.
- Initial configuration
Follow the manufacturer's instructions to configure the CA350C2 settings according to your application requirements. This may involve setting parameters via a connected interface.
- Calibrate the controller
Perform any necessary calibration procedures as outlined in the user manual to ensure accurate operation of the CA350C2 controller.

