
Contact for Pricing
Overview
- Frequency Range: 83-88 MHz
- Gain: 11 dBi
- Polarization: Vertical
- Connector: N-female / TNC-female
- Radome: UV resistant ABS/FG with PU foam filling, IP67 rated
Specifications
Connection Type | N-/TNC-female |
Connector | N-/TNC-female |
Frequency | 83-88 MHz |
Gain | 11 dBi |
Length | 12280 mm |
Material | copper, ABS/FG PU foam |
Mounting Diameter | Ø 35-60 |
Mounting Type | 35-60 mm diameter pole |
Polarization | vertical |
Radiator Material | copper |
Radome | FG, PU foam |
Series | CA85C4 |
VSWR | <1.5 |
Weight | 6460 g |
Wind Load | 336 N @ 150 km/h |

CA230C4
offset pattern collinear - Frequency range: 221-239 MHz - Gain: 11 dBi - Polarization: vertical - Connector: N-/TNC-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 180 NHow to Install the CA85C4 Controller
This guide provides step-by-step instructions for installing and configuring the CA85C4 Controller, ensuring proper wiring and setup for optimal performance.
Estimated time: 45m
Tools needed:
Screwdriver, Wire strippers, Multimeter
Supplies needed:
Mounting screws, Self-amalgamating tape, Terminal connectors
- Mount the controller
Secure the CA85C4 controller to the designated mounting surface using the provided mounting screws. Ensure that the controller is level and securely fastened.
- Connect the wiring
Use wire strippers to prepare the ends of the wires. Connect the wires to the appropriate terminals on the CA85C4 controller, ensuring that each connection is tight and secure.
- Seal the connections
Cover all connectors and cable junctions with self-amalgamating tape to provide weather protection. Ensure that the tape is applied evenly and securely to prevent moisture ingress.
- Verify the connections
Use a multimeter to check the continuity of the connections. Ensure that all connections are functioning correctly before proceeding with the setup.
- Configure the controller
Follow the manufacturer's instructions to program the CA85C4 controller settings according to your specific application requirements.
- Calibrate the system
Perform any necessary calibration procedures as outlined in the user manual to ensure the controller operates within the desired parameters.

