
Contact for Pricing
Overview
- Frequency range: 380-410 MHz for targeted wireless communication
- 8 dBi gain with vertical polarization for optimal signal coverage
- N-/TNC-female connector for secure and stable cable connections
- IP67-rated UV-resistant ABS/FG PU foam radome for environmental protection
- Wind load rating: 68 N with aluminum alloy mounting bracket
- Operating temperature: -40°C to +80°C for extreme environments
- DC-short circuited feed point and integrated RF choke for enhanced performance
- Compatible with 35-60 mm diameter poles for flexible installation
Specifications
Connection Type | N-/TNC-female |
Connector | N-/TNC-female |
Frequency | 380-410 MHz |
Gain | 8 dBi |
Length | 1140 mm |
Material | ABS/FG PU foam, copper |
Mounting Diameter | Ø 35-60 |
Mounting Type | 35-60 mm diameter pole |
Polarization | vertical |
Radiator Material | copper |
Radome | ABS/FG, PU foam |
Series | CA |
VSWR | <1.5 |
Weight | 1630 g |
Wind Load | 68 N @ 150 km/h |

CA450C2
offset pattern collinear - Frequency range: 440-475 MHz - Gain: 8 dBi - Polarization: vertical - Connector: N-/TNC-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 64 NHow to Install the CA400C2 Controller
This guide provides step-by-step instructions for the installation and initial setup of the CA400C2 Controller, including wiring and calibration.
Estimated time: 1h
Tools needed:
Screwdriver, Wire strippers, Multimeter
Supplies needed:
Mounting screws, Wire connectors, Self-amalgamating tape
- Mount the controller
Secure the CA400C2 controller to the designated mounting location using the provided mounting screws. Ensure it is level and firmly attached.
- Connect the wiring
Strip the ends of the wires and connect them to the appropriate terminals on the CA400C2 controller. Use wire connectors to secure the connections.
- Seal the connections
Cover all connectors and cable junctions with self-amalgamating tape to ensure proper weather protection.
- Verify the connections
Use a multimeter to check the voltage at the controller terminals to ensure proper power supply.
- Calibrate the controller
Follow the manufacturer's instructions to perform the initial calibration of the CA400C2 controller, ensuring all settings are configured correctly.

