
Contact for Pricing
Overview
- Frequency Range: 221-239 MHz
- Gain: 8 dBi
- Polarization: Vertical
- Connector: N-female / TNC-female
- VSWR: <1.5
- Radome: UV resistant ABS/FG, PU foam filling
- Radiator Material: Copper
- Mounting: Ø 35-60 mm pole
- IP Rating: IP67
- Lightning Protection: DC-short circuited
Specifications
Connection Type | N-/TNC-female |
Connector | N-/TNC-female |
Frequency | 221-239 MHz |
Gain | 8 dBi |
Length | 1955 mm |
Material | ABS/FG PU foam, copper |
Mounting Diameter | Ø 35-60 |
Mounting Type | 35-60 mm diameter pole |
Polarization | vertical |
Radiator Material | copper |
Radome | ABS/FG, PU foam |
Series | CA |
Series | CA230C2 |
VSWR | <1.5 |
Weight | 1890 g |
Wind Load | 90 N @ 150 km/h |

CA450C2
offset pattern collinear - Frequency range: 440-475 MHz - Gain: 8 dBi - Polarization: vertical - Connector: N-/TNC-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 64 NHow to Install the CA230C2 Controller
This guide provides step-by-step instructions for installing and configuring the CA230C2 Controller, ensuring proper wiring and initial setup.
Estimated time: 45m
Tools needed:
Screwdriver, Wire strippers, Multimeter
Supplies needed:
Mounting screws, Self-amalgamating tape, Terminal connectors
- Mount the controller
Secure the CA230C2 controller to the designated mounting surface using the provided mounting screws. Ensure it is level and firmly attached.
- Connect the wiring
Use wire strippers to prepare the wires and connect them to the appropriate terminals on the CA230C2 controller. Ensure all connections are secure and properly insulated.
- Seal connections
Cover all connectors and cable junctions with self-amalgamating tape to protect against weather conditions. Ensure that the tape is applied evenly and securely.
- Verify connections
Use a multimeter to check the continuity of the connections. Ensure that all connections are functioning correctly before proceeding.
- Initial configuration
Power on the CA230C2 controller and follow the manufacturer's instructions to complete the initial setup and configuration.

