2 AWG Nylon Insulated Ring 5/16" Stud, 10 Per Pack

Two Way Receptacle For .157 Male, 25/Pack

Voltage Marker Card 240 Volts, 12ea. .5x2.25"

Voltage Markers 440 Volts, 1ea. 9x2.25"

Power Distribution Block-Small (2) 2/0-14 AWG Primary (6) 4-14 AWG Secondary Power Distribution Blocks are made of high strength, high-conductivity aluminum alloy and are mounted in a high-strength glass-filled polyester base. Each block can stand alone or combine with other blocks to form a multi-block set.

Power Distribution Block (2) 500 MCM-4 AWG Primary (4) 4/0-6 AWG Secondary Power Distribution Blocks are made of high strength, high-conductivity aluminum alloy and are mounted in a high-strength glass-filled polyester base. Each block can stand alone or combine with other blocks to form a multi-block set.

U-Type Compression Die - Pink 1/0 AWG Copper - 2 AWG Aluminum U-Shaped Compression Dies are for use with the NSi-12 Compression Tool and Other Tools. See Cross-Reference Chart below.

U-Type Compression Die - Pink 500 MCM Aluminum U-Shaped Compression Dies are for use with the NSi-12 Compression Tool and Other Tools. See Cross-Reference Chart below.

Manual 16" Cable Cutter - 350 MCM APPLICATIONS: Rugged and lightweight manual cable cutter for use with steel.

Rotatable Socket for Short Term Lighting allows you to re-position the socket to direct the light to where it is needed while helping to keep the cords tidy and out of the way. Rated for up to 200 Watts.

The Polaris ITG-1 Grey Multi-Tap Single Side Entry Connector features 2 ports sized for 1 - 10 AWG Class B, C or D wires or 2 - 10 AWG Class K, M or I wires. The body is made from aluminum alloy wrapped in a layer of plastisol insulation. Each port is specially designed for fine-stranded copper wires and pre-loaded with an oxide inhibitor, with removable access plugs over the hex screws used to tighten the connections. Installs with a hex key and torque wrench, without any tape or additional supplies. Designed for use in a wide range of splicing fine-stranded wire applications, including installation in cable trays, troughs, wire-ways, raceways, ducts and motor junction boxes.

The Polaris ISR-600 Multi-Tap In-Line Entry Connector features 2 ports sized for 600 MCM - 6 AWG wires. The body is made from aluminum alloy wrapped in a layer of plastisol insulation. Each port is pre-loaded with an oxide inhibitor, with removable access plugs over the hex screws used to tighten the connections. Installs with a hex key and torque wrench, without any tape or additional supplies. Designed for use in a wide range of splicing applications, including installation in cable trays, panel boards, ducts, raceways or troughs.