
Contact for Pricing
Overview
- Offset pattern collinear design for focused signal transmission
- Frequency range: 405-440 MHz
- Gain: 8 dBi
- Vertical polarization
- Durable ABS/FG radome with PU foam filling and IP67 rating
Specifications
Connector | N-/TNC-female |
Frequency | 405-440 MHz |
Gain | 8 dBi |
Length | 1070 mm |
Mounting Diameter | Ø 35-60 |
Polarization | vertical |
Radiator Material | copper |
Radome | ABS/FG, PU foam |
VSWR | <1.5 |
Weight | 1605 g |
Wind Load | 66 N @ 150 km/h |

CA930C2
offset pattern collinear - Frequency range: 880-960 MHz - Gain: 8 dBi - Polarization: vertical - Connector: N-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 50 NHow to Install the CA420C2 Controller
This guide provides step-by-step instructions for installing and configuring the CA420C2 Controller, ensuring proper wiring and initial setup.
Estimated time: 45m
Tools needed:
Screwdriver, Wire strippers, Multimeter
Supplies needed:
Mounting screws, Terminal connectors, Self-amalgamating tape
- Mount the controller
Secure the CA420C2 Controller to the designated mounting surface using the provided mounting screws. Ensure it is level and firmly attached.
- Connect the wiring
Strip the ends of the wires and connect them to the appropriate terminals on the controller. Use terminal connectors to ensure a secure connection.
- Seal the connections
Cover all connectors and cable junctions with self-amalgamating tape to provide weather protection and prevent moisture ingress.
- Verify the installation
Use a multimeter to check the voltage at the controller terminals to ensure proper power supply. Confirm that all connections are secure.
- Configure the controller
Follow the manufacturer's guidelines to program the CA420C2 Controller settings according to your application requirements.
- Calibrate the system
Perform any necessary calibration procedures as outlined in the user manual to ensure optimal performance of the CA420C2 Controller.

