Showing 1981-1992 of 452,171 results

ACS880 AC Drive, 3-380-500V In, 700HP, 857A, Type OPEN, 1.1 overload, Assistant Bluetooth, HxWxD 68.54x13.78x19.92 in, Module, EMC/RFI-filters, 2nd Environment, Unrestricted (Unearthed Network), Common mode filter, DC cable connection busbars
Contact for Pricing

Contact for Pricing

Contact for Pricing
EL100-2M/6x10/100TX-2x100FX-MM-SC IE Switch (Managed/Ring/Extended)
Contact for Pricing

Contact for Pricing

CompleTech
CA420Y+++++
directional yagi - Frequency range: 405-440 MHz - Gain: 13 dBi - Polarization: vertical/horizontal - Connector: N-/ TNC-/ 7/16-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 173 N
Contact for Pricing

Braking Resistor, 8.06 OHMS, 5119 WATTS, GCE9 Enclosure, 26.5W x 10D x 5H in, 24 lbs
Contact for Pricing

The three phase field supply converters DCS800-S01 and -S02 drives need a separate active over voltage protection for proper operation on the inductive load of a motor field. This unit will protect the drive against inadmissible high voltages. The DCF506-0140 is to be used with -0020-05 through -0140-05 units.
Contact for Pricing

CABINET DRIVE ULTRA LOW HARMONIC, Product Family: ACS800, Horsepower: 450 HP, Output Current: 571 A, Voltage: 480 VAC, Voltage Range: 380-500V, NEMA 1 / UL Type 1 (IP21), Floor-mounted, Local or Remote Mounted LCD Display and Keypad, 0510 KVA, 3-Phase Input, 3-Phase Output, Frame: R8i, Product HxWxD: 91.1 in x 48.4 in x 25.4 in, Product Weight: 2090 lbs
Contact for Pricing

DRIVE CFW500B24P0T4DB66DSG2 WEG specifications: Power supply 380-480 V; Input phases Three-phase; Configuration With options; Rated current (HD) 24 A; RFI filter Without filter; Enclosure IP66; Dynamic braking Standard with braking; Safety Stop Prepared to install the accessory CFW500-SFY2
Contact for Pricing

Externally mounted, half controlled 3-phase field exciter, with single quadrant operation. This field supply is current regulated with a max output current of 35 amps. With 1-phase input, an autotransformer is recommended for voltage adaptation. An input line reactor is required when supply voltage is over 400 Vac. Fuses are always required. DSL communication cable is required. Communication to the converter unit is required via the SDC-DSL-4 board, standard in D5-D7 and all drives 600 Vdc or greater, otherwise optional.
Contact for Pricing

Contact for Pricing