Showing 2413-2424 of 452,163 results

CompleTech
CA860Y++++
directional yagi - Frequency range: 830-890 MHz - Gain: 12 dBi - Polarization: vertical/horizontal - Connector: N-/ TNC-/ 7/16-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 76 N
Contact for Pricing

CompleTech
CA450Y++++
directional yagi - Frequency range: 440-475 MHz - Gain: 12 dBi - Polarization: vertical/horizontal - Connector: N-/ TNC-/ 7/16-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 135 N
Contact for Pricing

Mencom Corporation · Mencom
MIN-2MR-1-PG13.5
MIN Size I, Receptacle, 2 Pole, Male Straight, 1 Ft, 16awg, 13A, PG13.5, Front Mount, Aluminum Clear Anodized
Contact for Pricing

Contact for Pricing

Contact for Pricing

ABB - Electrification · GE
9T21S1100
ABB's Servicenterâ„¢ Single-Phase Integral Transformer and load center system comes equipped with an encapsulated transformer wired into rightly sized circuit breakers for both the primary and secondary transformer windings. Qualified to the seismic requirements of IEEE-693-2005 and IBC-2021 and CBC 2022. Accessible mounting flanges with keyhole slotted mounting holes to make installation easy. NEMA 3R painted enclosure. Clear, comprehensive documentation and labeling. The Servicenter system is UL Listed and is suitable for use service equipment with a 10 kAIC short circuit current rating. The load center portion of this system is ready to accept the ABB THQL plug-on circuit breakers.
Contact for Pricing

Contact for Pricing

NSI Industries · Polaris · Connector Blocks
AL-V1-K6
Power Distribution Block 1000-250 MCM Primary 2/0-14 AWG Secondary Power Distribution Blocks are made of high strength, high-conductivity aluminum alloy and are mounted in a high-strength glass-filled polyester base. Each block can stand alone or combine with other blocks to form a multi-block set.
Contact for Pricing

NSI Industries · NSI · Polaris Black
ITO-4
The Polaris ITO-4 Multi-Tap Offset Dual-Side Entry Connector features 2 ports sized for 4 - 14 AWG wires. The body is made from aluminum alloy wrapped in a layer of plastisol insulation. Each port is pre-loaded with an oxide inhibitor, with removable access plugs over the hex screws used to tighten the connections. Installs with a hex key and torque wrench, without any tape or additional supplies. Designed for use in a wide range of splicing applications, including installation in cable trays, panel boards, ducts, raceways or troughs.
Contact for Pricing

Contact for Pricing

Contact for Pricing
Minimum Qty: 15
Multiplier: 15
*Contact for lower quantities*

Contact for Pricing