Showing 3037-3048 of 452,163 results

Contact for Pricing
Contact for Pricing

ER-72KV is a sensing resistor accessory used on systems up to 72 kV (non-continuous duty) to monitor the continuity of a neutral-grounding resistor. It is an accessory for SE-330HV.
Contact for Pricing

Littelfuse · M1000 Series
M1000.0080
Alarm Annunciator12-24V DCIP54. The M1000 is an Alarm Monitor capable of surveying the state of up to 10 potential free contacts. The inputs of the M1000 can be used to monitor both normally open (NO) and normally closed (NC) contacts. Each contact can be sourced to a positive or negative reference. The M1000 includes a total of 10 inputs. Each input controls two bright red LEDs and an open collector output. A built-in relay provides audible alarm through control of an external siren. The first incoming alarm is indicated with a quick flashing light, following alarms are indicated with slow flashing light. LEDs will keep flashing until the alarms are acknowledged, even though the input signal has been deactivated. Pressing the RESET pushbutton will acknowledge all new alarms whereby all flashing LEDs will change to steady light, provided that the related inputs are still active. Pressing the RESET push button will also silence the siren. The reset sequence is programmable.
Contact for Pricing

The NH system is classified among plug-in fuse systems and is composed of: • fuse-base (possibly including terminal covers and phase barriers) • fuse-link with blade contact • fuse-link replacement device (LV HRC fuse puller) Since the design of this system cannot guarantee non-interchangeability of rated current, it must be handled by a qualified professional. 690 Volts 500 Amps gG NH3 with striker series.
Contact for Pricing
Minimum Qty: 3
Multiplier: 3
*Contact for lower quantities*

Contact for Pricing

Contact for Pricing

Braking Resistor, 8 OHMS, 15488 WATTS, GCE30 Enclosure, 28W x 16D x 10H in, 70 lbs
Contact for Pricing

Interface cable for communication between the DCF external field supply and the DCS800 drive and/or between DCS800 drives. The cable supports communication for 12 pulse operation and drive-to-drive communication with the SDCS-DSL-4 board. This cable is 33 feet (10 m) long and has ferrule-tipped wires on both ends.
Contact for Pricing

R1 Flange Mounting Kit for the ACS550 drives allows mounting the drive with the heatsink external to a 3rd party enclosure. Use of the flange kit requires removal of the drive cover, reducing protection to IP00. R1 through R4 flange kits can be used with 3rd party UL Type 1 & 12 (NEMA 1 & 12) enclosures.
Contact for Pricing

R2 Flange Mounting Kit for the ACS550 drives allows mounting the drive with the heatsink external to a 3rd party enclosure. Use of the flange kit requires removal of the drive cover, reducing protection to IP00. R1 through R4 flange kits can be used with 3rd party UL Type 1 & 12 (NEMA 1 & 12) enclosures.
Contact for Pricing

ABB - Installation Products · STA-KON
RCT863
Fluoropolymer Insulated Ring Terminal For Wire Range 12-10 Stud Size #8, Clear/Yellow Stripe
Contact for Pricing
Minimum Qty: 500
Multiplier: 500
*Contact for lower quantities*