Motorized Potentiometer. The E7800 Motorized Potentiometer is typically used as an interface between increase/decrease relay contacts (or push buttons) and a device requiring control by an external potentiometer (e.g. the speed trim of an electronic governor). All three wires of the potentiometer are directly accessible on external connection terminals, thus providing the best possible flexibility for almost any application. A special version of the E7800 with DC voltage output is also available. The DC output voltage follows the position of the potentiometer. The design of the E7800 ensures that the potentiometer will “remember” its position although supply is lost

Megaohmmeter. 96x96mm. The Megaohmmeter E2323 are designed for connection with the Insulation Monitor T3200 for instrument readings. Flush mounted units with standard measurements of 96 x 96 or 144 x 144.4.

FlexGen Generator Controller - Advanced. Integrated generator controller. The C6200 provides load depending start and stop, automatic synchronization and active / reactive load sharing for one diesel generator (3 phase). The C6200 will also ensure that the generator is always operating at the nominal speed / frequency no matter the load. Advanced grid paralling and Power Factor function are provided as standard. Programmable inputs and outputs allows for easy integration with PLC control. The C6200 can be operated in either fully automatic mode, semi-automatic mode or in manual mode.

FlexGen UI User Interface. The user interface unit FlexGen UI can be connected to any FlexGen controller through the RS232 serial link. The user interface is designed for mounting in the switch panel door. It furnishes a large back-lit display showing all electrical measurements and control parameters. Separate LEDs provide clear indication of the generator mode and condition. In addition to showing actual alarms when they appear, the unit includes a valuable alarm log, showing previous alarms with information about the time and date when they occurred. This feature is providing a powerful tool in maintenance and service of the installation. Furthermore control keys are included enabling onsite configuration.

Detects phase current or ground-fault current. (200-A primary)

Detects phase current or ground-fault current. (200-A primary)

Watertight cover. Tamper-resistant. IP65 protection. Accessory for the MPS and FPS.

Protective Cover. Watertight cover. Tamper-resistant. IP65 protection. Accessory for the MPS and FPS.

Remote indication and reset for the SE-134C and SE-135. NEMA 4 and NEMA 13 rating. Standard 22-mm mounting.

TRAFO SPÆND. 380-440/21V 6VA. Trafo Spaend. 380-440/21V 6VA .

KABEL RS-232 SERIEL 9PHAN/HUN. RS-232 Serial Cable. 9PHAN/HUN.

50-W ground-check termination assembly with convenient mounting holes and wire leads.