The FiberRunner 2x2 Outside Vertical attaches to a channel to create a 45 downward angle from a straight horizontal run. It is used with inside vertical 45 angle fitting FIV452X2LYL to change the level of straight horizontal runs.

The FiberRunner 24x4 End Cap Fitting is used for closing off open ends of the channel or fittings. The end caps assist in creating a structure that protects fiber optic and high-performance copper data cabling from physical damage.

The FiberRunner 6x4 Outside Vertical Right-Angle Cover creates openings for easy access to add or remove cables.

PVC Coated Cable Tray Conduit Clamp, Conduit Size 1-1/2 Inch, Gray

WALL ANGLE FOR 18IN LADDER

Used to support the 6x4 and 4x4 systems from any new threaded rod installations. Bracket is secured to threaded rod with two nuts. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16" nut driver on slide clamps, For 16mm Threaded Rod.

The FiberRunner Horizontal Right-Angle Split Cover is used for the 12x4 horizontal right-angle fitting within a cable routing system. It has a snap-on feature that allows the cover to be installed and removed with no tools required. The horizontal right-angle split cover creates a radiused 0.750 (19mm) opening for easy access to add or remove cables.

The FiberRunner 12x4 Horizontal Tee attaches to the 12x4 channel and/or fittings to create a 90 horizontal branch with a 12x4 exit from a straight horizontal run.

The FiberRunner 4x4 Horizontal Tee attaches to the 4x4 channel and/or fittings to create a 90 horizontal branch from a straight horizontal run.

Optional split cover for the four way cross fitting FRFWC4X4YL. Snap-on feature allows cover to be installed and removed with no tools required. Creates radiused 3/4 (19mm) opening for easy access to add or remove cables.

Used to support the 12x4 system by spanning two threaded rod drops that are 18in apart. Can be installed from above or below. Bracket is secured to each threaded rod with two nuts. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16in nut driver on slide clamps, For 5/8in threaded rod.

Used wherever additional FiberRunner Slide Clamps would be helpful. For example, use on 12x4 FiberRunner QuikLock Brackets to accommodate dual runs of 6x4 or 4x4 FiberRunner Channel.