The FiberRunner 1-Port Spillout is used with a 2x2 fitting. The spillout is used to route cable into three separate 1.5 inch (3.8mm) diameter split corrugated tubing.

The FiberRunner 4x4 Horizontal Tee Split Cover is optional for for the horizontal tee fitting FRT4X4LYL. The snap-on feature allows the cover to be installed and removed with no tools. The split cover creates a radiused 0.75 inch (19mm) opening for easy access to add or remove cables.

CL - 4 BAY CONFIG 42"

The FiberRunner 2x2 channel cover is an optional snap-on for the hinged channel. The cable channel cover features a hinge that can open to 90 from either side of the channel and can be removed completely if desired. It comes in 10 feet in length.

The FiberRunner 4x4 Spill-Over Junction is used to fully enclose 4x4, 6x4, 12x4, or 24x4 channels. It mounts directly to the existing installation with no alteration required.

The FiberRunner 6x4 Outside Vertical Right-Angle Cover creates openings for easy access to add or remove cables.

CABLE LADDER 18W RACK WALL KIT

The FiberRunner 24x4 4-Way Cross Fitting attaches to 24x4 channel and/or fittings to create a horizontal 4-way cross intersection with two 24x4 exits.

Used to support the 12x4 system from below with new threaded rod. Bracket is secured to threaded rod with two nuts. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16in nut driver on slide clamps. Also can be secured directly to the top of cabinets, For 5/8in threaded rod.

The Top of Cabinet Bracket for Wire Basket allows pathway up to 36" wide to be mounted 2.25" above a continous row of FlexFusion cabinets that are 1070mm deep. It can be used with the Elevation Kit to provide additional space between pathway and cabinets. It comes in powder-coated black finish, with all necessary hardware.

WALL ANGLE FOR 12IN LADDER

40x80 wire retainer