
Contact for Pricing
Overview
- Frequency Range: 83-88 MHz
- Gain: 8 dBi
- Polarization: Vertical
- Connector: N-female / TNC-female
- IP67 Rated Construction
Specifications
Connection Type | N-/TNC-female |
Connector | N-/TNC-female |
Frequency | 83-88 MHz |
Gain | 8 dBi |
Length | 5220 mm |
Material | copper, ABS/FG PU foam |
Mounting Diameter | Ø 35-60 |
Mounting Type | 35-60 mm diameter pole |
Polarization | vertical |
Radiator Material | copper |
Radome | FG, PU foam |
Series | CA85C2 |
VSWR | <1.5 |
Weight | 2920 g |
Wind Load | 168 N @ 150 km/h |

CA860C2
offset pattern collinear - Frequency range: 830-890 MHz - Gain: 8 dBi - Polarization: vertical - Connector: N-female - VSWR: <1.5 - Radome: ABS/FG PU foam - Radiator material: copper - Mounting: 35-60 mm diameter pole - Wind load: 50 NHow to Install the CA85C2 Controller
This guide provides step-by-step instructions for installing and configuring the CA85C2 Controller, ensuring proper wiring and calibration.
Estimated time: 1h
Tools needed:
Screwdriver, Wire strippers, Multimeter
Supplies needed:
Mounting screws, Wire connectors, Self-amalgamating tape
- Mount the controller
Secure the CA85C2 controller to the designated mounting surface using the provided mounting screws. Ensure it is level and firmly attached.
- Connect the wiring
Use wire connectors to attach the power and signal wires to the appropriate terminals on the CA85C2 controller. Ensure all connections are tight and secure.
- Seal the connections
Cover all connectors and cable junctions with self-amalgamating tape to provide weather protection and prevent moisture ingress.
- Verify the installation
Use a multimeter to check the voltage at the controller terminals to ensure proper power supply. Confirm that all connections are functioning correctly.
- Calibrate the controller
Follow the manufacturer's instructions to enter the calibration mode on the CA85C2 controller and adjust settings as necessary for optimal performance.

