Showing 7693-7704 of 452,166 results

All Littelfuse Class G fuse blocks offer snap-to-release DIN rail mounting and universal mounting holes. Class G fuse blocks are designed for use with time-delay current limiting Class G fuses.
Contact for Pricing

The LFJ1000 solar fuse block is specifically designed for the Littelfuse SPFJ 1000 Vdc Solar Fuse. It meets UL electrical characteristic requirements and is available in multiple amperages.
Contact for Pricing

Remote indication and reset for the SE-105 and SE-107. NEMA 4 and NEMA 13 rating.
Contact for Pricing

Littelfuse · SE-145 Series
SE-145-00-00
3 Channel GF-GC Monitor. The SE-145 is a three-channel, microprocessor-based, combination ground-wire monitor and ground-fault relay for resistance-grounded or solidly grounded systems. It continuously monitors the integrity of the ground wire to protect portable equipment from hazardous voltages caused by ground faults. The SE-145 is designed for use on three-way splitter box applications. COMPUTER TO RELAY CONNECTION: Connect the SE-145 to the network using a standard Ethernet patch cable. Use of a crossover cable to connect the SE-145 directly to the computer running SE-MON-GFGC is not recommended. A typical router will assign an IP address to all connected computers that are using DHCP. The SE-145 does not support the use of DHCP. If the SE-145 is being set-up for first time, it is recommended to only have one SE-145 connected to the network to prevent communication errors.
Contact for Pricing

SE-325D is a neutral-grounding resistor monitor with a supply voltage of 120 ac-dc and a ground-fault trip level of 0.5–4.0 A.
Contact for Pricing

Littelfuse · Relay Series
T4900.0030
VAr Load Sharer. 415/480V 5A. The T4900 is designed to control a generator operating in parallel with the grid, or a generator operating in parallel with other generators (which are also controlled by T4900 units). The T4900 will continuously measure and compare the reactive current on the generator to an external DC reference signal connected to the “parallel line” input. The T4900 will increase or decrease the voltage of the generator (through the AVR) if it finds the reactive current level to be either too low or too high. Two built-in relays provide the increase and decrease pulses for the automatic voltage regulator (AVR). The strength (width) of the pulses is proportional to the voltage deviation. The E7800 Motorised Potentiometer can be used to adapt the contact pulses to a signal suitable for most AVR’s.
Contact for Pricing

Littelfuse · Relay Series
T4400.0130
Load Sharer. 415/480 VAC 5A. The T4400 is designed to control a generator operating in parallel with the grid, or a generator operating in parallel with other generators (which are also controlled by T4400 units). The T4400 includes built-in frequency control and an optimized regulation scheme. These two features provide near perfect stability and compensates for any drift within the speed controller. A soft load/unload facility is also included.
Contact for Pricing

50-W ground-check termination assembly with convenient mounting holes and screw terminals.
Contact for Pricing

Littelfuse® fuse reducers allow smaller size fuses to be installed into existing fuse clips to prevent overfusing.
Contact for Pricing

INDICATING PANEL 344 Bar Knob 16-32V. Panel Mount Enclosed Fuse Holders for 3AG/AB Fuses.
Contact for Pricing

KLDR02.8 is a Class CC fuse with an ampere rating of 2.8.
Contact for Pricing
Minimum Qty: 100
Multiplier: 100
*Contact for lower quantities*

Littelfuse · 215 Series
0215016.MXP
SLO-BLO CERAMIC FUSE M-PACK 16A. The 215 series is 5x20, Ceramic body, Time-Lag type Cartridge fuse. With the extension into higher current ratings beyond existing 12A, from 15A up to 25A in cartridge version, in particular for 20A and 25A, it offers designers better flexibility in circuit protection design for high current applications.The 215 Series has remarkable interrupting capability at operating voltage of 250VAC. In addition, it can be used in AC applications, and it provides a smaller footprint of 5 x 20mm as compared to 6.3 x 32mm for same applications. Features: Offer high ampere ratings Provide remarkable interrupting capacity UL agency approval. Applications: Primary and Secondary protection for White Goods, UPS/Power Supplies, High current applications.
Contact for Pricing
Minimum Qty: 1000
Multiplier: 1000
*Contact for lower quantities*