FlexGen UI User Interface. The user interface unit FlexGen UI can be connected to any FlexGen controller through the RS232 serial link. The user interface is designed for mounting in the switch panel door. It furnishes a large back-lit display showing all electrical measurements and control parameters. Separate LEDs provide clear indication of the generator mode and condition. In addition to showing actual alarms when they appear, the unit includes a valuable alarm log, showing previous alarms with information about the time and date when they occurred. This feature is providing a powerful tool in maintenance and service of the installation. Furthermore control keys are included enabling onsite configuration.

Detects phase current or ground-fault current. (200-A primary)

Detects phase current or ground-fault current. (200-A primary)

Watertight cover. Tamper-resistant. IP65 protection. Accessory for the MPS and FPS.

Protective Cover. Watertight cover. Tamper-resistant. IP65 protection. Accessory for the MPS and FPS.

Remote indication and reset for the SE-134C and SE-135. NEMA 4 and NEMA 13 rating. Standard 22-mm mounting.

TRAFO SPÆND. 380-440/21V 6VA. Trafo Spaend. 380-440/21V 6VA .

KABEL RS-232 SERIEL 9PHAN/HUN. RS-232 Serial Cable. 9PHAN/HUN.

50-W ground-check termination assembly with convenient mounting holes and wire leads.

Alarm Annunciator48-110V DCIP54. The M1000 is an Alarm Monitor capable of surveying the state of up to 10 potential free contacts. The inputs of the M1000 can be used to monitor both normally open (NO) and normally closed (NC) contacts. Each contact can be sourced to a positive or negative reference. The M1000 includes a total of 10 inputs. Each input controls two bright red LEDs and an open collector output. A built-in relay provides audible alarm through control of an external siren. The first incoming alarm is indicated with a quick flashing light, following alarms are indicated with slow flashing light. LEDs will keep flashing until the alarms are acknowledged, even though the input signal has been deactivated. Pressing the RESET pushbutton will acknowledge all new alarms whereby all flashing LEDs will change to steady light, provided that the related inputs are still active. Pressing the RESET push button will also silence the siren. The reset sequence is programmable.

SE-MRE-600 is a moisture-resistant enclosure kit specifically designed for the ER-600VC and ER-1000HV sensing resistors. This enclosure protects the connection terminals from snow and rain in outdoor applications. The dimensions measure 4.8 H x 4.7 W x 3.3 D in.

The SE-CS30 series is a sensitive nickel-core current transformer used with Littelfuse relays to detect low levels of earth-leakage current.