Small-Format Termination Assembly. Compact 12-W ground-check termination assembly with convenient mounting holes and screw terminals.

Universal PC Board. 12-110V DC. Universal PC Board. 12-110V DC.

The SE-CS30 series is a sensitive nickel-core current transformer used with Littelfuse relays to detect low levels of earth-leakage current.

Relay Sockets & Fixings NGR VOLT SCALER 500-10KV

IP54Cover w/handle for M1000,M2000&M2100. IP54 Cover with handle for M1000, M2000 and M2100.

Energized Phase Indicator. Energized Phase Indicator.

M2000 Engine Cont 12-24VDC IP54 at front. The M2000 Engine Controller will control and protect any industrial combustion engine, which accepts discreet I/O signals for control of the crank, the fuel valve and the stop solonoid (if applicable). The engine must be able to supply potential free contacts for starter disengagement and over speed alarm (normally done through a standard tacho relay). The M2000 is typically used as an engine controller for diesel or gas driven generator sets. The operator can start the engine either by pressing a button on the front facia, or by providing and external start signal through a potential free contact (e.g. a relay). The M2000 can be configured to perform multiple start attempts. The M2000 detects a successful start from the crank disconnect signal provided by the tacho relay (normally at 33percent of nominal speed). The M2000 will operate the fuel valve as well as a start warning signal shortly before cranking the engine. The progress of the start sequence is clearly indicated on the front facia LEDs.

Termination Assembly with Wire Leads - 50-W ground-check termination assembly with convenient mounting holes and wire leads.

Connects the SE-601 relay to an ungrounded 24 Vdc bus.

Connects the SE-601 relay to an ungrounded 24 Vdc bus.

Indicator Panel. 6 channels, 12V DC/AC. The M4500, M4600 and M4700 provide flush mounted LED based indication with 6, 8 or 20 channels. Each channel can be used to indicate the state of one potential free contact. The indicator units are available with either negative or positive reference. An insert paper label provides the opportunity to print a description or instruction right next to the related channel LED. The indicator units are available for both DC of AC supply. Input signals can be +24 VDC, +48 VDC or +110 VDC. A TEST push button located on the front will, while activated, ignite all LEDs to confirm proper operation. An auxiliary push button is provided for application dependant use. The auxiliary push button is directly connected to the plug-in terminals on the rear side of the unit.

RELAY ELEC GF/GC PANEL MT KIT. Relay Electronic Ground Fault/Ground Check panel mount kit.