SE-325DN is a neutral-grounding resistor monitor with a supply voltage of 120 ac-dc and a ground-fault trip level of 0.5–4.0 A.

SE-325DSNT is a neutral-grounding resistor monitor with a supply voltage of 120 ac-dc and a ground-fault trip level of 0.5–4.0 A.

G3600 Voltage Relay. 24V DC. The G-Line relays are mainly intended for use in land-based applications. The G-Line relays provide an efficient solution for applications where flexibility and cost of purchase are the main issues. G-Line relays provide high quality, proper measuring techniques and a vast number of programmable options.

Motorized Potentiometer24VDC, 10turn,100. The E7800 Motorized Potentiometer is typically used as an interface between increase/decrease relay contacts (or push buttons) and a device requiring control by an external potentiometer (e.g. the speed trim of an electronic governor). All three wires of the potentiometer are directly accessible on external connection terminals, thus providing the best possible flexibility for almost any application. A special version of the E7800 with DC voltage output is also available. The DC output voltage follows the position of the potentiometer. The design of the E7800 ensures that the potentiometer will “remember” its position although supply is lost

Alarm Annunciator. Alarm annunciator. Compact unit for flush mounting. 8 input contacts normally open or normally closed. Time delays 50 msec. - 15 sec. individually selectable on all channels. One common output relay for sirenand two programmable output relays for alarms with voltage free contacts. LED color change through plug-in system. Plug-in terminal block for easy service. Two integrated push buttons for siren reset/lamp test and alarm accept. DC or AC supply voltage. Remote individual selectable blocking with adjustable unblocking delay 1 - 15 sec. External dimming possibilities.

SE-325S is a neutral-grounding resistor monitor with a supply voltage of 120 ac and a ground-fault trip level of 0.5–4.0 A.

ATyS C65 universal ATS controller

PUMP RELAY, 16A BUILT-IN CTS, 240VAC. The PGR-6800 Pump Protection Relay provides protection for pumps with three-phase motors up to 1,000 Vac. No current transformers are required for currents up to 91 A. The protective functions include overload, phase unbalance, phase loss, phase sequence and undercurrent. The PGR-6800 Pump Protection Relay is ideally suited for applications where operating without load can induce failure. Motor current is monitored and an undercurrent trip occurs when the current drops below a preset level. No additional level detectors are required.

CT 100:1 WITH FLUX COND 31MM

RB121-12VDC

RB121PG-5VDC

CR-M230AC2 PLUGGABLE INTERFACE REL.