Fitting, 90 Degree, Height 1-7/8 Inches, Base Length 2 Inches, Hole Diameter 9/16 Inches, Electro-Galvanized Steel with Magnets

Fitting, 90 Degree, Height 4-1/8 Inches, Base Length 3-1/2 Inches, Hole Diameter 9/16 Inches, Electro-Galvanized Steel with Magnets

Fitting, 90 Degree, Height 1-7/8 Inches, Base Length 2 Inches, Hole Diameter 9/16 Inches, Steel with Magnets

Surface Raceway and Lighting Systems, Tapped End Cap, 12 gauge, Steel, Electro Galvanized, for 3/4 inch or 1 inch Conduit, Furnished complete with 1/4 inch X 5/8 inch flat head machine screw and AB100-1/4 Springless Nut. For E Series Channel.

Channel Bracket. 90 Degree Angle. 1 Hole on short side, 9/16 Inch Diameter. 7-7/8 Inch X 1-5/8 Inch. Width 3-1/2 Inch. Thickness 1/4 Inch. Zinc coating is applied by hot-dipping after fabrication. Is in conformance with ASTM A-123, Grade 65 specification standards. Minimum of 2.5 mill thickness.

A 2 hole open 45 degree corner angle. It is made of electro-galvanized steel with a zinc plated finish. The angle is 45 degrees and is used as a steel angle component.

A Z fitting corner brace with 3 holes. It is zinc plated. The sheet identifies it as catalog number FZB3HEG.

Z fitting 2 hole support with an 8 inch length. It is made with a zinc plated, electro-galvanized finish. The sheet lists a thickness of 1/4 inch, an outside width of 1-5/8 inch, and hole diameter of 9/16 inch.

Z fitting slotted support with a zinc plated finish. The sheet identifies it as FZSSEG and indicates a 2-pack. No additional dimensional or material attributes are listed on the product attributes section.

Z-Fitting Cross 2-Hole for 1-5/8 inch channel. It is made from Type 304 stainless steel. The sheet identifies it as catalog number FZX2H162S4.

Fitting, 90 Degree, Height 4-1/8 Inches, Base Length 1-5/8 Inches, Hole Diameter 9/16 Inches on 1-7/8 Inch Centers, Electro-Galvanized Steel

Fitting, 90 Degree, Height 4-1/8 Inches, Base Length 3-1/2 Inches, Hole Diameter 9/16 Inches, Type 316 Stainless Steel